AngstromBond/DSM DS-2015 UV固化二次涂覆胶水， 1kg包装
This Safety Data Sheet (SDS) has been prepared in accordance withthe requirements of the OSHA Hazard Communication Standard (CFR 291910.1200). Section 2. Hazards identification SKINCORROSION/IRRITATION - Category 2 SERIOUS EYE DAMAGE/ EYEIRRITATION - Category 2A SKIN SENSITIZATION - Category 1 TOXIC TOREPRODUCTION [Fertility] - Category 2 Classification of thesubstance or mixture : Signal word : Warning Hazard statements :H319 - Causes serious eye irritation. H315 - Causes skinirritation. H317 - May cause an allergic skin reaction. H361 -Suspected of damaging fertility. Hazard pictograms : Precautionarystatements Prevention : P201 - Obtain special instructions beforeuse. P202 - Do not handle until all safety precautions have beenread and understood. P281 - Use personal protective equipment asrequired. P280 - Wear protective gloves. Wear eye or faceprotection. P261 - Avoid breathing vapor. P264 - Wash handsthoroughly after handling. P272 - Contaminated work clothing shouldnot be allowed out of the workplace. Response : P308 + P313 - IFexposed or concerned: Get medical attention. P302 + P352 + P362-2 +P363 - IF ON SKIN: Wash with plenty of soap and water. Take offcontaminated clothing. Wash contaminated clothing before reuse.P333 + P313 - If skin irritation or rash occurs: Get medicalattention. P305 + P351 + P338 - IF IN EYES: Rinse cautiously withwater for several minutes. Remove contact lenses, if present andeasy to do. Continue rinsing. P337 + P313 - If eye irritationpersists: Get medical attention. Storage : P405 - Store locked up.Disposal : P501 - Dispose of contents and container in accordancewith all local, regional, national and international regulations.GHS label elements OSHA/HCS status : This material is consideredhazardous by the OSHA Hazard Communication Standard (29 CFR1910.1200). Hazards not otherwise classified : None known. Date ofissue/Date of revision : 7 April 2014 Version : 1 Page: 1/13 SafetyData Sheet DeSolite® DS-2015 Section 2. Hazards identificationHazardous Material Information System (U.S.A.) The PPE (PersonalProtection Equipment) designation in the HMIS is provided for useby employees at supplier sites only. Other users of this productare encouraged to evaluate the hazards of the product and assignPPE that is applicable to their specific situations. PERSONALPROTECTION Health Flammability Physical hazards BG * 1 1 2 Caution:HMIS® ratings are based on a 0-4 rating scale, with 0 representingminimal hazards or risks, and 4 representing significant hazards orrisks Although HMIS® ratings are not required on SDSs under 29 CFR1910.1200, the preparer may choose to provide them. HMIS® ratingsare to be used with a fully implemented HMIS® program. HMIS® is aregistered mark of the National Paint & Coatings Association(NPCA). HMIS® materials may be purchased exclusively from J. J.Keller (800) 327-6868. The customer is responsible for determiningthe PPE code for this material. Section 3. Composition/informationon ingredients There are no additional ingredients present which,within the current knowledge of the supplier and in theconcentrations applicable, are classified as hazardous to health orthe en
