JB/T9536的WF2腐蚀等级分享中,其中二氧化硫腐蚀试验Sulfur dioxide corrosiontest的时间久:
试验参数 Test parameters | 0.67 | ||
试验周期 Test cycle | 第1阶段 Phase I | 8h | |
第二阶段 Phase II | 16h | ||
总测试时间 Total test time | 24h | ||
暴露条件 Exposure conditions | 第1阶段 Phase I | 温度 Temperature | 40℃ |
相对湿度 Relative humidity | 约1oo%(在样品上产生凝结水) About 1oo% (condensate generated onthe sample) | ||
第二阶段 Phase II | 温度 Temperature | 23℃±5℃ | |
相对湿度 Relative humidity | ≤75% | ||
试验箱底部水量(体积百分比) Water volume at the bottom of the test chamber (volumepercentage) | 0.67% | ||
在低温阶段结束前3h测量绝缘电阻,在进行工频耐压试验。 Measure the insulation resistance 3 hours before the end of the lowtemperature stage, and conduct the power frequency withstandvoltage test.绝缘电阻:电压500V;绝缘电阻值≥2MΩ。Insulation resistance: 500V;Insulation resistance value ≥ 2MΩ工频耐压:电压1500V;应无绝缘击穿或表面闪络现象。Powerfrequency withstand voltage: 1500V; There shall be no insulationbreakdown or surface flashover. |
其他项目测试的周期大概需要3天左右,测试周期大概13天,加上测试报告的,一般会预留一些时间出来,正常需要两周左右完成!
讯科检测是的第三方检测机构,取得国家认可,也有WF2国家授权资质