| Testitem 测试名称：ToiletSeats of Moulded Plastics 模压塑料的坐便圈 | |
| Testinfo 测试内容： | |
Clause | TestRequirement |
3 | Material 材料 |
3.1 | Plastics materials for seatsand flaps 便圈以及便盖的塑料材料 Excludingthe ageing test （老化试验除外） |
3.2 | Buffermaterials 缓冲器材料 |
3.3 | Materials for hingeing devicesand bolts and nuts 铰链设计以及螺栓螺帽的设计 |
3.3.1 | Stainlesssteel 不锈钢 |
3.3.2 | Copperalloy 铜合金 |
3.4 | Washers 垫圈 (same toclause 3.3) |
4 | Design 设计 |
5 | Workmanship 工艺 |
6 | Dimensions 尺寸 |
7 | TestRequirement 测试要求 |
| Water absorption (Non-rigidonly) 吸水率（非坚硬的样品）(for seat orcover) | |
| Impactresistance 抗冲击性 （for seat orcover) | |
| Rigidity (Applicable to seatsmade of rigid plastic only) 坚硬度测试（适合用坚硬塑料制成的便圈） | |
| Rigidity (Applicable to flapsmade of rigid plastic only) 坚硬度测试（适合用坚硬塑料制成的便盖） | |
| Staining by the cover orseat 被着色性 | |
9 | Marking 商标 |
| Sampling Requirement:3 sets of completed products withassembly instruction (if applicable） | |
| 样品要求： 全套样品3套并包含安装说明书（如适用） | |
| Turnaround time: normal (9 workingdays)； express（7 workingdays） | |
| 所需时间： 标准（9个工作日）；加快（7个工作日） | |
| Note: Rigid —plastics that have a modulus of elasticity in flexure or tensiongreater than 700 Mpa. | |
| 注：坚硬材料—拉伸试验的弹性模数大于700Mpa的塑料。 | |
Sample for reference参考图片:
Sample Report报告样本：
