测漏点料机smt零件计数器IC贴片点料机

<测漏>

产品规格（测漏型）Productspecification

电源：AC220/110，50HZ，25W

Powersource: AC220/110,50HZ,25W

计数范围：-99999--99999PCS

Counting scope: -99999--99999PCS

外型尺寸：L470*W300*H180mm

Outlook size:L470*W300*H180mm

重量：10KG

Weight:10KG

The seventhchapter leak hunting

一、按测漏/LOSS键2秒钟，在右上方显示LOS,进入测漏程序，当料盘走动，如料带有漏料时，则会发出报警声并停止运行。

According tohunts leaks the /LOSS key 2 seconds,in the upper right demonstratesLOS, enters the leak hunting procedure, when the material platetakes a walk ,when the material has leaks the material, will thenexude the warning sound and stops the movement.

二、当出现报警时，按下停止/清零键后，再按下左转键或右转键，料盘会继续转动。

When presents thewarning, after pressing down the stop/resets the key, then pressesdown the counterclockwise key of turns right the key, expects theplate to be able to continue to rotate

注意：当进行测漏操作时，如果有出现死机现象（按键不起作用）时，可以用手来回拨动一下料盘即可。

Attention:Whencarries on the leak hunting operation,when has appears halts thephenomenon (pressed key does not have an effect), may use the handback and forth to move the yummy treats plate then.

三、调节光纤头位置：Adjusts an optical fiberposition:

1、根据料在料带的高度来调节固定光纤头柱子高度（通过前后两螺丝调节柱子松紧）使两头光纤头正对。

       （Througharound two screw adjustment pillar loose and tight）causes two optical fiber just righthighly based on the material in a material belt altitude mixturecontrol fixed optical fiber pillar.

2、通过松紧把手调节滑块进而改变两光纤头前后距离。

  Thenchanges through the loose and tight the hand adjusting slider twooptical fiber and aft distance

        附注：机子中央的松紧把手逆时针方向是固定紧划块，顺时针方向是松开划块的，松紧把手上部分可以向上提动从而来调到固定位置。

        Annotated:Theloom central corner is fixed delimits tightly the hand counterclockwise the block ,clockwise is loosens delimits the block ,inthe corner the part may raise upwardly moves, thus transfers thefixed position.

3、如果两光纤头前后距离调至Zui大，遇有空料未报警，那么再通过调节放大器来增强对射光线强度（调节放大器，SENS上方旋钮可改变光线强度）

  Iftwo optical fiber fore-and -aft distance transfers to a big way,meets has free time the material not to report to the police ,then strengthens the correlation candle-power again through thetuned amplifier (tuned amplifier, above SENS knob may change candle-power)